When we use the glass cutter, if there is a mechanical failure, how do we deal with it? Here we will explain this knowledge. The glass machinery and equipment should be checked daily, recorded carefully, refueled before class, lubricated correctly, and cleaned, wiped and oiled in time after class. Manage glass mechanical equipment accessories. When the work is transferred or replaced, the equipment and the complete accessories should be transferred. Seriously carry out shift shift system and fill in shift record.

    In the event of an accident of glass machinery and equipment, measures should be taken to cut off the power supply, keep the scene, report to the team leader or workshop mechanic in time, and wait for treatment. The accident should be explained in real time. It is directly responsible for accidents caused by subjective reasons such as violation of operation and maintenance procedures.

    Before the glass cutting machine is cutting, the cutting speed can be set by the person in charge. In order to achieve the best cutting quality, there is an optimum cutting speed range between different operating speeds. This range can be selected according to the instructions of the equipment or determined by experiments. Because of the thickness and material quality of the material itself. Different factors, such as melting point, thermal conductivity and surface tension after melting, change the cutting speed accordingly.

    The following is a brief introduction to the speed setting of glass cutting machine, hoping to provide you with some reference.

1. Increasing the cutting speed appropriately can improve the quality of the incision, that is, the incision is slightly narrower, the surface of the incision is smoother, and the deformation can be reduced.

2. The cutting speed is too fast to make the cutting line energy lower than the required value. The jet in the cutting slot can't blow the melted cutting melt off immediately and form a larger drag. With the slag hanging on the cutting edge, the surface quality of the cutting edge decreases.

3. When the cutting speed is too low, because the cutting point is the anode of plasma arc, in order to maintain the stability of the arc itself, the anode spot or the anode area must find the conduction current near the cutting slit nearest to the arc, and at the same time, it will transfer more heat to the radial direction of the jet, thus widening the incision and melting the two sides of the incision. The material gathers and solidifies at the bottom edge to form slag hanging which is not easy to clean, and the upper edge of the incision is rounded because of excessive heating and melting.

4, when the speed is very low, the arc will even die out because of the wide incision. It can be seen that good cutting quality is inseparable from cutting speed.

    The above is about the speed of glass cutting machine introduction, I hope to help you! Anyone who wants to buy glass cutting machine can contact us. We look forward to working with you.